Online Sales: 480-990-7715
Scottsdale Store: 480-990-7690
                                            Rolling Mill Instructions

                                                          Rolling Mill & Rollers 6Pcs S-1181
                                                          Rolling Mill & Rollers 6Pcs S-1404

Unpacking the Rolling Mill

     1.    Remove Mill from the box.
     2.    DO NOT try to lift Mill by the T-bar. The T-bar will come out.
     3.    The crank handle is put on backwards for shipping purposes. Loosen the black
            hex nut and remove the handle, then turn the handle around and reinstall it.
            Don't forget to secure it with the nut. Be sure to leave the plastic handle free to turn.
     4.    For shipping purposes only the mill is covered in a coating of grease.
                                             

Operating Instructions

     1.      Remove the gear from the top roller, and the key stock.
     2.      Loosen the four bolts on the mill head, then lift and remove the mill head. Be
              sure to place the mill head on a clean surface.
     3.      DO NOT extend the T-bar past the top of the gears in order to ensure a good
              alignment.
     4.      Set the distance between the two rollers slightly thinner than the piece of metal
              you are working with.

     5.      Crank the handle in a clockwise direction while slowly feeding the metal
              between the rollers. If you find that it is too hard to crank, try opening up the
              distance between the rollers a little bit more. (Be careful to keep clear of the gears at all times.)
     6.      Continue to readjust the rollers after each pass through until you have the desired thickness.

 

Pattern Roller Replacement (if included)

     1.      Remove the gear from the top roller, and the key stock.
     2.      Loosen the four bolts on the mill head, then lift and remove the mill head. Be
              sure to place the mill head on a clean surface.
     3.      Slowly lift the top roller while keeping it level, and then place it on a clean
              surface. Be careful not too loose the springs between the rollers.
     4.      Slide the holders off each end of the roller.
     5.      Place the holders on the pattern roller, while making sure the springs are in place.
              Then reassemble the mill.
     6.      Carefully replace the roller into the bill, making sure the springs are in place.
              Then reassemble the mill.

 

Wire Roller Replacement (If included)

     1.      Remove the gear from the top roller, also remove the Key stock.
     2.      Remove the lower roller gears (large gear and small gear) also remove the Key
              stock.
     3.      Loosen the four bolts on the mill head, then lift and remove the mill head. Place
              the mill head on a clean surface.
     4.      Slowly lift the top roller, keeping it level and then place it on a clean surface. Be
              careful not to loose the springs between the rollers.
     5.      Loosen the setscrews on the back of the mill frame.
     6.      Remove the lower roller the same way as the top roller.
     7.      The wire rollers are different lengths. The longer roller will be the lower roller.
     8.      Starting with the lower flat roller that is being replaced, remove the holders from
              the ends and put on the lower wire roller. Place the roller into the mill frame,
              with the oil holes on top. Then tighten the screws. Make sure that the springs are
              installed. Do the same with the upper roller.
     9.      Double check to make sure everything is correct, and all the oil holes are on the
              top. Once this is done, replace the mill head.
     10.    Lube the mill as needed.
     11.    Keep the rollers free of any rust at all times.

 

 

 

 

Loading...